收藏本站
MAX2670
GPS/GNSS Front-End Amplifier
Detailed Description
The MAX2670 IC contains two LNA stages tuned for use
at 1575MHz.
AMP 1
AMP 1 has an internal load that limits the bandwidth and
provides a 50 I output impedance through a DC-blocking
capacitor. The internal biasing for AMP 1 suppresses
gain variation with changes in temperature and supply
voltage. At the input, an integrated DC-blocking capaci-
tor and matching network are intentionally omitted to
allow selection of external components to optimize for
noise or gain.
AMP 2 with Gain Step
The output of AMP 2 has the dual role of providing both
the RF output drive and receiving the DC power supply
through a single cable. Both the input and output ports
of AMP 2 are internally matched to 50 I impedance at
1575MHz. A 3.4dB gain switch can be used to adjust
the gain for different applications. The gain-select pin is
connected to an inverter with an internal pullup resistor.
Hence, the gain-select pin is set by default to high-gain
mode. Shorting the gain-select pin to ground sets the
gain stage to a 3.4dB lower gain. As with AMP 1, AMP
Alternate Supply (ALT_VCC)
The IC power can be supplied from the navigation sys-
tem through RFOUT2 (pin 5). An integrated filter is con-
nected to the output of LNA 2 to separate the supply volt-
age from the GPS signal. Alternatively, the supply voltage
can be applied to the external capacitor pin (pin 4).
Layout Considerations
For best performance, carefully lay out the PCB using
high-frequency techniques. Use controlled-impedance
transmission lines to interface with the MAX2670 high-
speed inputs and outputs and isolate the input sig-
nals from the output signals as much as possible. For
improved noise figure, keep the connection to the input
of LNA 1 as short as possible. A power-supply decou-
pling capacitor should be placed very close to pin 4 and
connected directly to a ground plane. If low-gain selec-
tion for LNA 2 is required, connect pin 7 directly to the
ground plane with a very short PCB trace. Good ground-
ing is critical for this device. The backside ground plane
should be as close as possible.
Refer to www.maxim-ic.com for the MAX2670 Evaluation
Kit schematic, gerber data, pads layout file and BOM
information.
2 has an internal load that limits the bandwidth, and the
amplifier’s internal biasing suppresses gain variation with
changes in temperature and supply voltage.
Typical Operating Circuit
LNA1 INPUT
SAW
LNA2 INPUT
ALT_VCC
V CC
REG
10
1
V CC
REG
4
6
LNA 1
LNA 2
5
RFOUT2/VCC
8/9
EXPOSED PAD
MAX2670
2/3
7
GAIN_SELECT
OPEN = 31.4dB GAIN
SHORT TO GROUND = 28dB GAIN
????????????????????????????????????????????????????????????????? Maxim Integrated Products 7
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
MAX2673EVKIT EVAL KIT MAX2673
MAX2676EVKIT+ EVAL KIT MAX2676
MAX2681EVKIT EVAL KIT
MAX2685EVKIT# KIT EVAL FOR MAX2685
MAX2688EVKIT+ EVAL KIT MAX2688
MAX2690EVKIT KIT EVAL FOR MAX2690
MAX2691EVKIT# KIT EVAL FOR MAX2691
MAX2693LEVKIT# EVAL KIT
相关代理商/技术参数
MAX2671EUT 制造商:Maxim Integrated Products 功能描述:- Rail/Tube 制造商:Rochester Electronics LLC 功能描述:
MAX2671EUT+ 制造商:Maxim Integrated Products 功能描述:UP/DOWN CONV MIXER 3.3V/5V 2.5GHZ 6PIN SOT-23 - Rail/Tube 制造商:Maxim Integrated Products 功能描述:Mixer/Upconv, 0.4-2.5GHz, MAX2671EUT+
MAX2671EUT+T 功能描述:上下转换器 400MHz to 2.5GHz Upconverter RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128
MAX2671EUT-T 功能描述:上下转换器 400MHz to 2.5GHz Upconverter RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128
MAX2671EUT-T+ 制造商:Maxim Integrated Products 功能描述:Upconverter Mixer,MAX2671 400-2500MHz
MAX2671EVKIT 功能描述:射频开发工具 MAX2660/61/63/71 Eval Kit RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
MAX2671EVKIT+ 制造商:Maxim Integrated Products 功能描述:HIGH-VOLTAGE WATCHDOG TIMERS WITH ADJUSTABLE TIMEOUT DELAY - Boxed Product (Development Kits)
MAX2673EUA 功能描述:上下转换器 400MHz to 2.5GHz Upconverter RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128